Halloween Display Stands

Randomly shopping, we found two glass domes that lent themselves well to a "mad scientist" decor for Halloween. All that was missing was simple round wooden pedestals with a groove. These displays will then be decorated with skulls, crows, skeletons, withered flowers, etc. With a little imagination, the possibilities are endless.

The Stands

For the building, I will use two raw board of pine skillfully chosen for their color and their veins. Below, one board per stand will be enough.

01-Halloween-display-stands
02-Halloween-display-stands
03-Halloween-display-stands

For the large stand, I cut the board and assembled it to obtain a square of 12″ (about 30.5 cm) of sides. I then made a template to make circles on my router table. Thanks to this one, I was able to realize the circular shape and the groove of the two stands. Below you can see the result of these steps.

04-Halloween-big-display-stand
05-Halloween-big-display-stand
06-Halloween-big-display-stand
07-Halloween-big-display-stand

Here, the stand adorned with its dome then decorated.

For the small stand, I used the same technique except that the dimension of the circle will be 6″ (about 15.25 cm) of diameter. Finally, I had to “damage” the stands a little to give them a more rustic and worn out by time.

Here is the small stand decorated with its dome and its decoration*.

*No scorpion was mistreated, it is plastic 😉

The Display Stands Completed

See you the next Halloween…

Share the Post:

Related Posts